Customer Review

TOP 500 REVIEWER
Reviewed in Australia on 2 August 2021
Where do I even begin? I have a Flashforge Adventurer 3. I tried this brand of PLA today. I could not get it to stick to the bed no matter what I did. Warps so bad and get unstuck from the bed while printing. Tried glue sticks, re-calibration of bed, different temps 200,210,215,220, nothing works! Attempted to print a little plastic piece 6 times NO LUCK!

At the same time Flashforge PLA works perfectly.
Customer image
Era
1.0 out of 5 stars Haven't had a single successful print!
Reviewed in Australia on 2 August 2021
Where do I even begin? I have a Flashforge Adventurer 3. I tried this brand of PLA today. I could not get it to stick to the bed no matter what I did. Warps so bad and get unstuck from the bed while printing. Tried glue sticks, re-calibration of bed, different temps 200,210,215,220, nothing works! Attempted to print a little plastic piece 6 times NO LUCK!

At the same time Flashforge PLA works perfectly.
Images in this review
Customer image
Customer image
3 people found this helpful
Report abuse Permalink